Married to a Nerd

We finally pulled the “Chocolate Pony” (our RV) onto the pad last night and set it up.  Everything went pretty good except for the water shooting all over the shower, thankfully the door was closed.  I forgot I had taken apart the shower fixture.  After that situation was brought under control I still heard a small water dripping noise.  It turns out the water line run to the ice maker in the freezer was disconnected or broken somehow.  The water ran down behind the fridge and soaked the floor causing havoc with our heat A/C controller.  Let’s just say we didn’t end up staying in the RV last night.  Hopefully when we go over there today the controller will be dried out and back to working order.

This got me thinking about winterizing the water line to the ice maker.  We’ve never actually ran the ice maker until we tried now.  I poked around and found some step-by-step instructions on witerizing the water line to the ice maker in your RV.

Follow these Steps:

1. Shut off water supply valve to ice maker.
2. Place a shallow pan under water solenoid valve.
3. Remove inlet fitting to ice maker water solenoid valve.  Drain water from the supply line.
4. Remove the plastic nut and water line from outlet side of water solenoid valve.  Drain water from the line.
5. Cycle ice maker several times while blowing compressed air through water solenoid valve. Be sure all water is out of the solenoid.  NOTE: Up to 40 PSIG air pressure can be used to clear the valve.
6. Reconnect and tighten lines on water solenoid valve. Leave the water supply turned off until temperatures are above 32°F/0°C.
7. Dry out ice maker mold assembly with soft cloth.  Place bail arm in UP/OFF position.

These instructions are taken from the manual for a Dometic, so I don’t know if they apply to everything out there.  I’m going to be looking at the connection through the back of the fridge on ours to see if they left it disconnected.  More info to continue the RV adventure…